Replace Raspberry Pi with Arduino UNO or NANO, TEENSY, FEATHER or ESP32.

The S-BRIDGE is an adaptor between any Raspberry Pi add-on card which used the I2C port for communication,  and five of the most popular processor platforms in use today: Arduino UNO and NANO, TEENSY, FEATHER and ESP32.  It has the same form factor with Raspberry Pi and an identical 2x20 pin connector where you can plug any  Raspberry Pi IO card which uses the I2C port for communication. On the opposite side, the card has male or female socket adapters where you can plug the replacement processor.

Since the S-Bridge can accommodate five different families of processors, it comes unassembled.  You will need to solder the 2x20 pin connecting to any Raspberry Pi add-on card, two pull-up resistors  on the I2C lines, and the connectors that fit your target processor.

See the User's Guide for detailed assembly instructions.

KIT CONTENT:

  • S-BRIDGE bare PCB
  • 2X20 male header (similar with Raspberry Pi GPIO connector)
  • 2 x 16 pin female headers
  • 1 x 40 pin male breakable header
  • Two 2.2K through hole resistors

Write a review

Note: HTML is not translated!
    Bad           Good
Captcha

S-BRIDGE Raspberry Pi Replacement Card Type1

  • $10.00


  • 2 or more $9.00
  • 4 or more $8.00

Related Products

S-BRIDGE User's Guide

S-BRIDGE User's Guide

Replace Raspberry Pi with Arduino UNO or NANO, TEENSY, FEATHER or ESP32. The S-BRIDGE is an adapt..

$0.00

Tags: S-BRIDGE