Thanks Alex. I'll give it a try.
I've finally gotten back to trying to debug this a bit more. I've been sharing some traces, etc. with the esptool maintainers. They suggested that the problem may be caused by the lack of ca...
I've finally gotten back to trying to debug this a bit more. I've been sharing some traces, etc. with the esptool maintainers. They suggested that the problem may be caused by the lack of ca...
Thanks Alex. I think I've been working a porting the Raspberry Pi code over myself, but I've run into a few challenges that are probably much more with my knowledge than anything else.
Thanks for the reply! I still haven't tried getting a 5V external power supply yet. I've been trying to get the full functionality of the 8 MOSFET board working by using laptop I wasn't having tr...
I completely understand that there isn't much to go on here. I've tried making the sure the drivers are in sync between the two machines, and even the same driver consistently fails on my desktop,...
Ok, so this gets stranger and stranger, and I'm not sure where to go from here: I've received the new board, tried it on my main dev computer (running Windows 11), and it gives me the same error :...
Just to close this off, it looks like the board is defective. Sequent Microsystems is shipping me a new board, which, on top of all the troubleshooting that Alex had me do, is wonderful customer s...
Alex, Thanks for going through all those troubleshooting steps. Here's photo of the backside of the card:
Just to double check as well, here is photo of the board with the switches set:
I still get the same error with Arduino IDE 1.8.19 :(
alexburcea said: I had the impression you use Arduino 2.x, but if this is not the case, forget about my last message. i not sure if I'm answering the ...
I've selected "DOIT ESP32 DEVKIT V1" in the arduino IDE. Do you mean to try a previous version of the Arduino IDE?
Thanks Alex. Is there any other troubleshooting I can do to determine that the problem is not between the keyboard and chair (as opposed to the board itself)?
Alex, Thanks for the reply! I've followed the instructions from the readme, and I'm now trying to build and upload the gpio example from the arduino IDE. I'm still getting the same error. Here'...
I've also notice that the LED on the board doesn't come on when I plug in the USB cable. Does the board need another power source other than the USB cable?
Sorry for the extreme newbie question, but it's been a bit since I've done any ESP32 Development. I've purchased an ESP32-Pi and a Eight MOSFETS 8-Layer Stackable HAT for Raspberry Pi a little whi...