- Breakout Card Type 1 Screw Mount 26-18 AWG for Raspberry Pi
- Routes all 40 I/O and power pins to screw terminal blocks
- Permits easy and secure field installation
- Prototype area for your custom projects
- 2.54mm Pitch PCB screw Terminal Block Connectors
- Rated voltage: 300V
- Rated current: 10A
- Wire range: 24 - 18 AWG
Screw Mount Breakout Card for Raspberry PiThis card can be used both for Raspberry Pi and for the Home Automation Card. The 2x20 pin header can be plugged into Raspberry Pi or into any stackable expansion card. It brings all 40 pins to screw-mount terminal blocks for conveniently wiring your project. Measuring only 104mm x 52mm, the card adds a prototype area with 5 x 40 PCB holes spaced at 0.1" apart where you can install your through hole parts for your own custom project. The terminal blocks accept 26 to 18 AWG wires and are rated 6A/150V.
Using the Breakout Card Type 1 for Raspberry Pi
Using the Breakout Card Type 1 for the Home Automation Card
PRACTICAL APPLICATION: Measure 10V signals using the HOME Automation Card
A 0-10V analog voltage output is one of the most common output signals used on process and HVAC instrumentation; due to the number of industrial controllers that will accept or input this signal. The Home Automation Card has 8 analog inputs which can read signals of 0-3.3V. If you want to read 0-10V signals, you need to add an external resistor divider. The Breakout Card Type 1 offers a very convenient way to implement this feature.
Assume you want to modify signal ADC0, which connects to Pin-19 of the expansion connector of the HOME Automation Card (see Schematic). As you can see in the layout, this pin connects to Pin-10 of connector J2.
1. Cut the trace from J2 Pin-10 to the 40 pin connector:
2.Install the resistor dividers.For this example we selected 1K and 2K resistors. You need to connect the two resistors in series, the connect open end of the 2K resistor to the input signal, and the open end of the 2K resistor to ground. The divided signal between the two resistors will be 1/3rd of the input signal and will be routed to the GPIO connector.
No more cuts or jumpers are required. You can solder the two resistors as shown in the picture below:
Now your Home Automation card can read 10V signals on ADC0. You can repeat the process for all analog inputs. You can also scale the input voltage to higher values using a different resistor divider.
OTHER BREAKOUT CARDS
We have three breakout cards for Raspberry Pi, to satisfy all your prototyping needs. All cards plug into the Raspberry Pi 40 pin GPIO connector and bring the IO's to different terminal blocks.
The card has a large prototype area of 5 x 40 holes at 0.1" spacing which can be used to test your own hardware. The terminal blocks accept 26 to 18 AWG wires and are rated 6A/150V.
Breakout Card Type 2.
This card uses spring loaded terminal blocks, which permit rapid connection to I/O pins without any tools. The card has a prototype area of 7 x 19 holes at 0.1" spacing which can be used to test your own hardware. The terminal blocks accept 22-18 AWG wires and are rated 5A-300V.
Breakout Card Type 3.
This card connects the GPIO pins to heavy-duty pluggable terminal blocks. It can use used both for Raspberry Pi and for the Home Automation Cards. The 2×20 pin header can be plugged into Raspberry Pi or into any stackable expansion card or HAT. The terminal blocks accept 24 to 14 AWG wires and are rated 8A/300V.